Introduction — ControlLogix Message to PLC-2 Processor In this section, we’ll cover how to send a ControlLogix Message to the PLC-2. The PLC-2 is now old, and obsolete. However, there are still quite a few systems that exist, and we need to get data from them. In this case, we’ll Read More »
Introduction to Rockwell Icom AI5 Software We used Rockwell Icom AI5 Software to program and troubleshoot the PLC-5 processor before RSLogix 5 came along. As a nostalgic post, I wanted to go back and review this legacy software. Those proficient with AI software claim they could navigate the software much Read More »
Introduction to Studio 5000 (RSLogix) Training When looking for Studio 5000 (RSLogix) Training options, it’s important to find a company that will customize the course. You need a company who will adjust the course according to your training needs. At the same time, the instructor should have knowledge of the Read More »
Introduction to DeviceNet Hardware In this post, I’ll discuss an example of common DeviceNet Hardware. DeviceNet is a networking protocol which will carry 24v along with the network cable. Therefore, this eliminates the hassle, in most cases, of running a separate 24v line to each device. A DeviceNet system typically Read More »
Introduction to Safety Relays Safety relays help to ensure the safe operation of your equipment when used with safety devices such as light curtains, e-stops, and safety mats. Generally, they will provide protection from shorted safety circuits, and open safety circuits as well. The safety relay can even provide protection Read More »
Introduction to ControlLogix Messaging over DH+ ControlLogix Messaging over DH+ allows us to read or write data over a DH+ Network. In this case, we will send a message to a PLC-5. We also use the same procedure to send a message to a SLC 5/04 over DH+. The PLC-5 Read More »
Introduction to Assigning an IP Address to the 1794-AENT In this section, we will be Assigning an IP Address to the 1794-AENT using the BootP Utility. If the IP address is already set, and we don’t know it’s IP address, we will reset it back to factory defaults, then re-assign Read More »
Introduction to ControlLogix Message Speed In this post, I’ll perform an experiment to test the ControlLogix Message speed. I’ve set up two processors as shown below. Basically, I’ll create a time stamp when I initiate a message instruction. Another FlexLogix processor will receive this message, and immediate send a message Read More »
Introduction to ControlLogix DF1 Messaging In this section, we’ll discuss ControlLogix DF1 Messaging to an SLC-500 processor. Connect the Serial port of an L6x or earlier ControlLogix to the serial port of an SLC-500 processor. We’ll use a NULL MODEM cable in this case. Albeit, there are faster communication protocols Read More »
Introduction to FactoryTalk View SE Trends and Data Log With FactoryTalk View SE Trends and Data Log, we will log background data, and plot that data onto a trend chart. Without the data log, the trend chart will only show live data at the time the trend was started. Basically, Read More »
