Introduction to FactoryTalk View Numeric Input In this section, we will discuss the FactoryTalk View Numeric Entry (cursor point) object. The purpose of the numeric input is to allow the operator to enter values into the processor. This could be the speed set-point of a drive, a temperature set-point, or Read More »
Introduction to FactoryTalk View Numeric Display In this document, we will discuss how to add and configure the FactoryTalk View Numeric Display. The purpose of the Numeric Display object is to display decimal numbers that are stored in the processor’s memory. This could be the speed of a drive, temperatures, or Read More »
Introduction to the FactoryTalk View Ellipse Animation In this document we will walk through the procedure of setting up the FactoryTalk View Ellipse Animation to simulate an indicator light. When a pump is running, the ellipse object will be green, and when the pump is shut off, the ellipse object will Read More »
Introduction to the FactoryTalk View Push Button Object The FactoryTalk View Push Button Object is very simple to add to your project. Using push buttons on a FactoryTalk View display saves time and money. Think about the cost of a physical button on a panel. Each button alone can Read More »
